Linksys wrt160n validating

WARNING: When flashing your router with custom firmware, there is always a small chance of bricking your router. = CSE31, CSE41 or CSE51 FCC ID = Q87-WRT160NV3 CPU Type = Broadcom BCM4716B0KFBG (BCMB83A chip rev 0) MIPS Rev = R2 CPU Speed = 300MHz Bus = ?The ribbon cable you will see in one of the pics, is connected to a serial header I hot glued to the side of the pcb. Done Chip ID b83a Chip Rev 0 Package Options 2 Number of Cores 5 Core Revision 63 Core Type 8830 Core Vendor ID 15200000 Flash Type 100 Flash Type = SFLASH_ST Dest is bits 0 Dest is bits1 0 Dest is bits 0 Flash is byteswapped 0 Endian Type is LE 0 PLL Type 00000000 00000000000000000000000000000000 (00000000) 00000000000000000000000000000000 (00000000) 00000000000000000000000000010010 (00000012) Done Flash Vendor ID: 00000000000000000000000011000010 (000000C2) Flash Device ID: 00000000000000000010000000010110 (00002016) *** Found a Macronix MX25L3205D (4MB) Serial Flash Chip *** - Flash Chip Window Start .... This router I purchased to assist the devs (Eko) in porting dd-wrt to this router. If you wish to experiment with a newer build, you should read the "build thread" for any build you are considering putting on your router, before flashing a newer build, (as discussed in the peacock announcement).

linksys wrt160n validating-16linksys wrt160n validating-33linksys wrt160n validating-11

Antenna Connector Type = Internal Wireless Standard = IEEE 802.11b/g/n Wi Fi Operating Frequency = 2.4GHz 802.11n Draft = up to 300Mbps 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11b = 1, 2, 5.5, 11Mbps Radio cor_rev = 17 Radio Capabilities = ap sta wet led wme pio 802.11d 802.11h rm cqa mbss16 afterburner ampdu amsdurx amsdutx acktiming If the DD-WRT password change page does not display, your page request times out, or you can't ping 192.168.1.1, make sure both wireless and power lights are on steadily first, then do a hard power cycle (unplug the power from the router--do not do a 30/30/30 reset).

Enter the port to forward into both the External Port and the Internal Port boxes.

The protocol that you want to forward is selected from the Protocol box.

The basic process to open a port is: We think that forwarding a port should be easy. Our software does everything that you need to forward a port. When you use Network Utilities you get your port forwarded right now!

If your username and password do not work then please visit our Default Linksys Router Passwords page.

Leave a Reply